Page 1 of 1

2013 Ford F250 Base System

Posted: Tue Nov 22, 2022 6:57 pm
by velocitymotorsports
I have a 2013 Ford F250 with the base system and I had a F01 harness with the Maestro RR. In the instructions there is the OBDII harness and connector but the F01 harness I have does not have this. What pin locations and connector does this need to connect to n the Maestro harness ? I'll just hard wire this connection since the appointment is for tomorrow.

There is a PINK/BROWN and a PINK/RED wire that is not detailed in the RR instructions. Do these go to CAN HI / CAN LO

Thank you

Re: 2013 Ford F250 Base System

Posted: Fri Nov 25, 2022 8:32 pm
by clayton.keeling
If you dont have the OBD harness you can extend the twisted pair of red/brown yellow brown wires that have the small 2 pin plug coming off the 18 pin harness that would plug into the RR, and run these do the OBD2 pin 6(red/brown) and pin 14 (yellow/brown). these other two wires are not needed for your install. hope this helps!