2013 Ford F250 Base System

Group using the FO1 and FO2 firmware for Ford SYNC retention * see specific firmware for full feature list.
Post Reply
velocitymotorsports
12Volt Specialist
Posts: 276
Joined: Sun Nov 04, 2007 10:16 am
Location: Morden, Manitoba

2013 Ford F250 Base System

Post by velocitymotorsports »

I have a 2013 Ford F250 with the base system and I had a F01 harness with the Maestro RR. In the instructions there is the OBDII harness and connector but the F01 harness I have does not have this. What pin locations and connector does this need to connect to n the Maestro harness ? I'll just hard wire this connection since the appointment is for tomorrow.

There is a PINK/BROWN and a PINK/RED wire that is not detailed in the RR instructions. Do these go to CAN HI / CAN LO

Thank you
Jeff Sit, Owner & Installer
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Fleet GPS Installations
Morden, Manitoba
clayton.keeling
ADS Team
Posts: 10
Joined: Mon Jun 06, 2022 3:00 pm

Re: 2013 Ford F250 Base System

Post by clayton.keeling »

If you dont have the OBD harness you can extend the twisted pair of red/brown yellow brown wires that have the small 2 pin plug coming off the 18 pin harness that would plug into the RR, and run these do the OBD2 pin 6(red/brown) and pin 14 (yellow/brown). these other two wires are not needed for your install. hope this helps!
Clayton Keeling Maestro Technical Support
Automotive Data Solutions Inc.
8400 rue Bougainville Montreal, Quebec H4P 2G1 Canada
T 514.807.2888
TF 866.427.2999
Post Reply

Return to “Ford, Lincoln, Mercury, Mazda”