KENWOOD DDX9703S Dodge Challenger 2012

Post Reply
Joeetime
New User
Posts: 1
Joined: Tue Dec 19, 2017 10:45 pm

KENWOOD DDX9703S Dodge Challenger 2012

Post by Joeetime » Tue Dec 19, 2017 10:52 pm

Couple issues .

I have two from Gray Harnesses from ch1 that need to plug to matching harnesses in my Challenger but only the large one has match. Am I to disregard the second one?

The gauges on Kenwood displayed appear to be incorrectly labeled rpm is mph mph is rpm?

Tire Pressure sensors just read na? I have not driven the vehicle. Will be trying hat to see if it auto corrects.

Radio stays on after car is shut off?

User avatar
Dara DeGrand
ADS Team
Posts: 4802
Joined: Mon Dec 02, 2013 1:34 pm

Re: KENWOOD DDX9703S Dodge Challenger 2012

Post by Dara DeGrand » Wed Dec 20, 2017 8:32 am

If you don't have a place to connect the smaller plug, that's normal. Not all cars have that plug.

Reset your RR. This can be done through the setup menu of the Kenwood. The TPMS should start displaying after you drive it a bit.

As shown in step 2 of the install guide (page 62), make sure the red 2-pin connector is plugged into the black plug.

http://images.idatalink.com/corporate/C ... 170222.pdf
Dara DeGrand
Maestro Technical Support Manager
Automotive Data Solutions Inc.
8400 Bougainville, QC
T 514.807.2888
TF 866.427.2999

Post Reply

Return to “CH1 radio replacement solution”