Page 1 of 1

programming CS remotes to the HCF controller

Posted: Sat Sep 17, 2016 1:41 pm
by Aporter
Guessing I have a learning curve here. Only second HCF controller I've ever used, and the first one I've tried programming CS remotes to. 08 Pathfinder with alarm, standard key. NI4 install and the ftd100 was flashed. Swapped remotes (pro 902 and companion G7), swapped decoders (flashed again), reset controller, swapped blue cable for decoder, swapped ant cable, swapped antenna. I can't find the instruction for programming CS remotes, but I'm assuming it's the same as CS controllers, ignition on/off 5 times. Red led on controller when I do that, but it does not react to the remotes at all and times out. What am I not doing correctly here? Thanks

Re: programming CS remotes to the HCF controller

Posted: Thu Sep 22, 2016 11:43 am
by Murph
Adam I know you already got your answer. For anyone else looking for this on the HC-F product. It's off to on 5 times ending in the ON position.

All guides are being updated as we speak. Sorry for the inconvenience.