MAZDA
MA |
1x RED = No CAN activity. Check CAN wires. 2x RED = VIN not received. Call technical support 3x RED = Call technical support. 4x RED = Not able to perform KLON log properly. Check immobilizer connections. 5x RED = RX cut is reversed. Check immobilizer connections. 6x RED = KLON validation fail. Retry entire KLON procedure. If it still fails, call technical support. |
MA2 |
1x RED = No CAN activity. Check the CAN wire connections. 2x RED = Ignition never turns ON. Check the ignition wire connection. 5x RED = Check the Green/Red wire. It should be at the doorlock data (newer guide) and not to the PTS (older guide or maybe old T-harness). 6x RED = VIN does not match the vehicle selected during flash process. |
MA3 |
If the LED never blinks GREEN, press and release the module programming button. The LED will blink RED the error number: AFTER KLON If the LED begins flashing RED rapidly, the Klon data may be invalid. Try turning ignition OFF and start the car. If it doesn't work, reset module and repeat the entire programming sequence. |
MA4 |
1x RED = No CAN activity. Check the CAN wire connections. 2x RED = No VIN detected. Call technical support. 3x RED = VIN detected, but platform not found. Call technical support. 4x RED = N/A 5x RED = (Shows when press and hold progswitch) Immobilizer learn has failed. Contact tech support. 6x RED = VIN does not match vehicle selected during flash process. 7x RED = Klon doesn't match with key, retry learn. 9x RED = No keysense detected. Keep the key in ignition at this step! |
MA5 |
1x RED = No CAN activity. Check the CAN wire connections. 2x RED = Ignition never turns ON. Check the ignition wire connection. 3x RED = No VIN detected. Check the CAN wire connections. 4x RED = No unlock command detected. Press unlock on the OEM fob. |
MA6 |
1x RED = No CAN activity. Check the CAN wire connections. 2x RED = Ignition never turns ON. Check the ignition wire connection. 3x RED = No VIN detected. Check the CAN wire connections. 4x RED = No unlock command detected. Press unlock on the OEM fob. 5x RED = Key not held up to push button backup reader or unable to validate immobilizer data. Make sure to use the same key as Klon to turn ignition ON, check key position and immo data connection. 6x RED = Invalid klon data. Reset and relearn module from step 1, if problem persist contact tech support. |